P1336 obd2 code is an ignition inspection fault code

P1336 obd2 code must be checked at the crank sensor circuit and see if it is synchronized with the cam sensor.

P1336 Crankshaft sensor is out of sync with camshaft sensor test

If you get this code, the first thing to check is your distributor especially if you have an imported vehicle. Look for signs of oil in the distributor which can contaminate the signals being monitored by the ecm (engine computer).

Check also the wiring leading to the distributor and see if the wires are properly insulated away from hot exhaust which could burn the wires. Check also on the crank sensor location whether it is located in the front of the engine or at the flywheel at the rear of the engine. The same can be done for the cam sensor.

On engines with distributor, the cam sensor is usually located in the distributor and it will give you a lot of grief if not properly align and synchronize with the crank sensor. On some applications (like Ford), an alignment tool is required which is can be bought from your local parts store (cost about $31). If you install the distributor without proper timing, it will still run but the mileage will suffer and the above code showing up. For more details, please contact ATS.



Get UNLIMITED wiring diagrams for LIFETIME ATS membership good for 2 vehicles including ONE on ONE assistance 24/7 ONLY $49 (50% OFF), click on the LINK below:



More OBD2 Code Fixes

Copyright © 2016 ATS Certified Product